Best 410 Hulls For Reloading (2024)

FAQs

Best 410 Hulls For Reloading? ›

410. Most folks recommended H110 (or Win 296, same powder), or 300MP, and rated these three best for hull life. All were deemed to give good fit and 1300-1350 fps. While a few folks liked LilGun, most thought that was too hot on the hulls and reduced reloading life due to burned crimps.

Alliant Powder's new 410 is the only flake powder specifically designed for the exacting needs of . 410 skeet and field loads. Being the cleanest burning . 410 powder available, this new 410 is more efficient, with lower powder charge weights, providing optimum loading characteristics.

Federal Gold Medal Plastic, Remington STS Premier and Winchester AA HS were usually loaded in ammo marketed as target ammo, and the better hulls account in part for the higher price of that ammo. These hulls are the best choice for reloading, and most of them will last for at least five or six loadings.

The standard . 410 cartridge is a 2 1/2-inch shell that contains half an ounce of lead shot. The more common length . 410 you'll find today is 3 inches, which can hold 3/8 ounces of small steel shot or 11/16 to 3/4 ounces of lead.

Go with size 8 or 8½ for the average shot out in the open. For target shooting, size 9 gives the densest pattern, but you will need to shoot fast as the pellets seem to lose energy in no time. The . 410 shines up close!

H4350 is ideal in the WSM family of calibers (270, 7mm, 30, 325) and is also the standard in such cartridges as the 243 Winchester, 6mm Remington, 270 Winchester, 338 Winchester Magnum and many more. For magnums with light- to moderate-weight bullets, it can't be beat!

296 is also the powder type used by Winchester for factory loaded 410 bore AA loads. However, 296 is not suitable for most rifle cartridges. 748 is the powder of choice by Winchester and the U.S. military for 5.56mm and 223 Rem.

Slugs for Reloading. Dangerous Game Slugs are the best performing slug for almost every shotgun and barrel combination. Lethal downrange energy is combined with stunning accuracy - even in smoothbores. Single-unit wad/slug construction for fast, easy loading.

Loading your own shotgun shells is not economical if you shoot 12- and 20-gauge, but it is practical for tailoring ammo for specific applications. Twenty years ago, when lead shot and primers were cheap, it was economical to load your own shells if you shot a lot of ammo in trap, skeet and sporting clays.

Anywhere from zero (some types are NOT reloadable) to several thousand (full brass Greener shells). Most 8 to 12 times.

Why is there a shortage of 410 shells? ›

They're lightweight and easy to handle, making them perfect for hunting small game or smashing clays. This rise in popularity has led to a huge demand for . 410 ammo, and supplies just can't keep up. Now, let's not forget the impact of the COVID-19 pandemic.

If the barrel is stamped 3" Can you shoot 2 1/2-inch ammo, or can you only use 3 inch ? The Gun Guy: Yes. You can shoot 2 1/2 inch or 3 inch shells in your .

around 35 to 40 yards for birdshot. For most shooters using a . 410, about half of that last figure.

Your maximum effective range will depend on how your gun patterns, but don't expect to hunt beyond 30 yards. For deer-size game and personal defense from 30 to 50 yards, slugs are the best choice.

matching the right shell to the right game is the most important factor for using a . 410 for hunting… Slugs have a very limited range (around 30 yards) but within tht range they are close to a 357 mag round… 2.5 shells are great for pigeons, gophers and snakes around the farm…

A . 410 slug is typically 110 grains, Federal has theirs listed at 1775 FPS out of an unknown barrel length. Likely 20″.

Black powder is the only type of powder that should be used in muzzleloaders. However, synthetic substitutes, such as Pyrodex^®, also can be used. Be sure to use only approved substitutes. Don't use modern-day smokeless powders in black powder firearms.

Specifics will change by cartridge and bullet type, but in general a fast-burning powder is used for light bullets and low-speed pistols and shotguns. Medium-rate powders are used for magnum pistols, while high-velocity, large bore rifle cartridges will need slow powders, as they deliver the most overall power.